SMOK Devilkin 225W Kit with TFV12 Prince Tank

SMOK Devilkin 225W Kit with TFV12 Prince Tank

WARNING: Some products on this site contain nicotine which is an addictive substance.

SMOK Devilkin 225W Kit with TFV12 Prince Tank

Rating:
90% of 100

The brand-new SMOK Devilkin kit consists of a stylish yet powerful Devilkin MOD with a TFV12 Prince tank. The Devilkin features a blade-shaped front, back sides as well as curved lateral body to show its elegant lines. Powered by dual 18650 batteries (sold seperately), the Devilkin fires up to a maximum output of 225W.

ONLY AVAILABLE WHILE STOCK LASTS

Special Price AUD$69.99 Regular Price AUD$139.99
Availability: In stock
SKU
604951
or 6 interest-free payments of AUD$11.67 with

Quick Link

Smok TFV12 Prince Replacement Coils

SMOK Devilkin 225W TC Box Mod Features:

  • Dual High-Amp 18650 Battery - (Not Included)
  • 3 Different Modes
  • Premium Zinc Alloy Construction
  • High-Quality 1.3 Inch OLED Display
  • Hinged Bottom-Loaded Battery Door Access
  • Intelligent Atomizer Recognition 
  • Battery Series Connection
  • Spare Parts
  • Short Circuit Protection
  • Over-Heat Protection
  • Over Discharge Protection
  • 12 Seconds Cut-Off
  • MicroUSB Port - Firmware Upgrades 
  • 510 Connection 

SMOK TFV12 Prince Sub-Ohm Tank Features:

  • 25mm Base Diameter
  • 5mL Standard Juice Capacity
  • 8mL Maximum Juice Capacity - Convex Glass Extension
  • Superior Stainless Steel Construction
  • High-Grade Glass Reinforcement
  • High-Temperature Resistant - Explosion Proof
  • Convenient Top-Fill Rotary Design - Lock Button Mechanism
  • Massive Dual Adjustable Airflow Control at Base
  • 810 Cobra Resin Ultra-Wide Drip Tip
  • Performance-Grade V12 Prince Coil Structure
  • 0.12ohm V12 Prince-T10 Decuple Coils - rated for 60-120W
  • 0.4ohm V12 Prince-Q4 Quadruple Coils - rated for 40-100W
  • 510 Connection

Specifications:

  • Wattage Output Range: 6-225W
  • Voltage Output Range: 0.5-9V
  • Min Atomizer Resistance: 0.05ohm
  • Temperature Range: 200-600F
  • Supports Ni200 Nickel, Titanium, and Stainless Steel Heating Elements

The standard edition kit includes:

  • 1 Devilkin Mod
  • 1 TFV12 Prince Tank
  • 1 V12 Prince – Q40 0.4ohm Quadruple Coils ( Pre-install)
  • 1 V12 Prince –T10 0.12ohm Decuple Coils
  • 1 Replacement Glass Tube
  • 1 USB Cable
  • 1 User Manual

How to use:

Battery installation:

  1. Press the flower-shaped button and then the battery box will pop out
  2. Place the two 18650 batteries into the device in the correct direction
  3. Push the battery box into the mod

3 modes available:

  • VW Mode
  • TC Mode (Ti, Ni, SS)
  • Memory Mode

Top refill system:

  1. Hold the tank with one of your hands and use the other one to press the top of the cap and move it counterclockwise.
  2. Add E-liquid through the slot and pay attention not to drip it into the central airflow tube.
  3. Close the cap carefully and firmly, then let it stand for several minutes to get the organic cotton completely saturated.

How to build the RBA

  1. Before starting make sure your hands are clean
  2. Take RBA deck apart
  3. Installing and positioning the pre-wrapped coil then place the coil between the posts and wrap the ends around the screws and tighten up. Once it is all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
  4. Cutting the ends of wire off.
  5. Cutting a strip of cotton and make sure it’s not too much and not too less.
  6. Inserting the cotton, and placing it in the middle.
  7. Cutting the cotton at an angle and make sure it’s not too short and not too long.
  8. Wet the coil with your E-liquid and adjust the cotton.

 

Write Your Own Review
You're reviewing:SMOK Devilkin 225W Kit with TFV12 Prince Tank
Your Rating
We found other products you might like!